![clien d'oeil :wink:](./images/smilies/icon_wink.gif)
Merci
![M. Vert :mrgreen:](./images/smilies/icon_mrgreen.gif)
nan il été pas fait avant j'ai juste vu le tuto et j'avais le matos alors... rien a fair de mon apréme alors... ^^" si non il spin pas mal j'aime bien ^^Atayack a écrit :Je rêveSpenblue a écrit :mon mien !!![]()
[ http://7b.img.v4.skyrock.net/7b3/footderuedu17/pics/2406169575_1.jpg ]
mal moder ><? A peine posté ce tuto que tu l'as déjà moddé ? xD
Il était déjà fait avant ?
En tout cas lé bô le tien.
Ah mince ! Il est en anglais ! Je me demande bien pourquoi je ne l'avais pas mis du début ...1)Gather your materials.
2)Dismantle the G2 as shown in the picture. Keep what is circled and discard or put away what is crossed out.
3)Cut the front G2 piece, the clickerpice, and the ColorTwin/KeiTyo/Miffy&Melanie/SuperTip sign pen piece as shown in the picture.
4)Take the second part of the clicker and cut/sand down the ridges on its outside. then wrap the cut/sanded piece with some celophane tape; enough for the Signo tip to screw on.
5)Assemble the pieces as such. Make sure that the Signo tip is screwed on very tightly.
6)Using a combination of celophane tape and telfon tape. secure the Signo tip/G2 clicker pieces to the G2 body. Also use the tapes to make the back part as cylindrical as possible up to the signo tip.
7)Using any means necessary, get one of the G2 grips on the barrel, up until the point at which you start to see tape. Set this piece aside for now.
8)Take the front G2 piece and sand down the lump near the front so that it is flush with the rest of the piece. Then wrap 2 sections of tape around the body even with the ridge near the threads. Next, screw on the Signo tip as tightly as possible onto the front.
9)Using a combination of celophane tape and teflon tape, make the rest of the body as cylindrical as possible up to the Signo tip. Use the picture as reference.
10)Repeat step 7 with the grip on this piece. Try to make these two pieces look as similar as possible.
11)Line up the two pieces and cut where shown. DO NOT cut the threads. Only cut the piece that is being pointed at.
12)You should now have what is shown in the picture.
13)Slide on your extra grips onto the remaining parts of the pieces. Try to keep them as symetrical as possible. Make it so that only a tiny bit of grip hangs off the edges of the pieces as shown in the picture.
14)Insert the Bic Round Stic inktube into the front of the cut ColorTwin/KeiTyo/Miffy&Melanie/SuperTip sign pen.
15)Shove in some tissue paper inside the barrel to reduce rattling.
16)Put the pieces together as shown in the picture. Before hand, you may choose to apply an outsert. If not, continue putting the pieces together. If you decide otherwise later, then just take them appart and apply it then.
17)You have just made a G2-CTE Vortex!
Ma session vidéos-------------> http://thefpsb.penspinning.fr/viewtopic ... 13&start=0Roupen a écrit : j'adore ses backs j'y peut rien x) ca ma rappelé hideaki